Skip to main content

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - 5doorgti

1
I.C.E & Electrical / Re: 1990 wiring woes
I also saw whilst trawling for info that relay position 3 should have a relay numbered 32, apparently ecu control or power relay i think I read..... I dont have a relay in that position.  Cant remember if I did prior to pulling the car apart!
2
I.C.E & Electrical / Re: 1990 wiring woes
small update......

so i found 5 mins to have a quick fiddle with the golf, i have now got a spark at a plug end but only when turning the ignition on and off, not when cranking.

still no buzz from the ISV and the fuel pump still not running unless i bridge the terminals.

i have just printed off the CE2 wiring info from the link above (thanks again Monkey), i guess im gonna have to try and continuity test each individual wire? unless someone suggests an instant plug / sensor i can try / check?! fingers are crossed on the latter!
5
I.C.E & Electrical / Re: 1990 wiring woes
Thanks for your reply, is there a way of testing / checking the hall sender?

And nope,no spark from the king lead, I have 12v on the no. 15 terminal, ive tried another (used coil) same result, of course the second coil could be shot!
6
I.C.E & Electrical / 1990 wiring woes
Hi all, so a bit of backstory....

A now ex friend and I started restoring my 5 door GTI around 2 years ago, all was going well, he stripped the car, i welded it, then it went to paint, anyways, ive been reassembling the car its all back together apart from radiator and a few trims.

i have however run into some difficulties with the electrical side, the engine bay wiring was all tied up against the firewall so it was out of the way for paint, ive refitted the engine, connected all the plugs etc that i could see / identify, im at the point of turning the key and............ nothing, well not nothing nothing, it turns over but not start.

i have discovered that theres no spark, i have 12v at the coil.
the ISV doesnt buzz when ignition is on.
fuel pump doesnt prime. ive bridged the terminals on the relay and the pump primes


everything else electrical appears to be working at this stage

really hoping someone has some possible suggestions as to where to start!
7
New Members Say Hi! / Another new one!
Hi all, my names Andy, from Norfolk (uk) and im currently restoring a 5 door 1990 GTI, i have some electrical questions but thought id better say hello before i bombard the tech section!